Arm bases for custom fabricated
arms
Model 140D/200D Clamps are designed to meet virtually any clamp handling
requirement in the 10,000 to 20,000 lbs. capacity range. Non-sideshifting,
sideshifting and revolving models are available.
The basic clamp is equipped with two bolt-on arm pads. These pads are
designed to be used as bases for custom fabricated arms. Existing arms
or forks may also be welded to the pads.
Several types of specialized arms are described below. If you have an
application requiring custom fabricated arms, contact Cascade's Application
Engineering Department at 800-CAS-CADE (227-2233).
|
 |
Pallet forks/fork positioners
Bolt-on standard forks are available from Cascade. Forks are manufactured
to meet specific customer size requirements. Model 150D Fork Positioners
are also available with a capacity of 15,000 lbs. Unlike conventional fork
positioners, Cascade 150D Fork Positioners have the added capability of
extending the forks beyond the frame. |
 |
Pulp & cotton bale arms
Bolt-on standard forks are available from Cascade. Forks are manufactured
to meet specific customer size requirements. Model 150D Fork Positioners
are also available with a capacity of 15,000 lbs. Unlike conventional fork
positioners, Cascade 150D Fork Positioners have the added capability of
extending the forks beyond the frame. |
 |
Multiple paper roll clamp arms
Paper roll handling arms are available for handling multiple roll configurations.
Arms are designed and manufactured to meet specific customer application
requirements. The basic configurations are for two roll handling or four
roll handling.
Multiple roll arms should be used on nonsideshifting and sideshifting
clamps only. Multiple roll handling arms are not available for Model 140D
and 200D Revolving Clamps.
|
 |
